Accessibility Tools

Fricks Cave Preserve
Walker County, Georgia
Fricks Cave Preserve
This email address is being protected from spambots. You need JavaScript enabled to view it.
Surface Only Permits Primitive Camping

Frick’s Cave in Georgia is the summer home of over 5,000 endangered Gray bats, Georgia’s only known population of the rare Tennessee cave salamander, and 33.8 acres of north Georgia karstland. Without a doubt, Frick’s is Georgia’s richest biologic spelean environment. It is one of only two Gray bat caves in Georgia. The cave is in Walker County on the eastern flank of Lookout Mountain.

Due to the presence of the endangered bats and salamanders, Frick’s Cave is closed to all visitation, except as authorized by the SCCi Board, Entry into the cave may constitute harassment as defined in Section 9 of the federal Endangered Species Act and is punishable by imprisonment and fines up to $50,000. Please respect the endangered wildlife in this delicate cave.

You can visit the preserve during warmer months to watch the nightly bat flight from the cave.

Closed to recreational visitation
No
No
Yes
No
Yes
None
Gravel
No
No
39
ET Davis, Andi Potter, Alan Potter
This email address is being protected from spambots. You need JavaScript enabled to view it.

NSS LogoThe following basic safety information is provided with permission from the National Speleological Society. To learn more about caving or find a local grotto (chapter) of the National Speleological Society visit www.caves.org. While you are there, become a member!

Basic Safety Information

There are several versions of cave safety guidelines. Having adequate training and reliable equipment are the main points in each one. Safe use of equipment can be achieved only by sharing information, teaching and demonstrations. Chances of being injured are reduced by awareness of dangers and by knowledge of your equipment and techniques.

Statistically, caving accidents are mostly attributed to poor judgment, little or no caving experience and falls. The most common causes of caving accidents include: falling, being struck by falling objects and hypothermia.

Falling: To reduce the risk of falling, one should avoid jumping and uncontrolled sliding down slopes, wear proper footwear, check and discard any faulty or worn vertical equipment and obtain proper training. When caving, you should always try to have three points of contact when moving over uneven ground. This means having three points on your body supported on immovable objects to stabilize your body while moving through difficult areas.

Falling Objects: Injury caused by falling objects are best avoided by always wearing a helmet. It is best to stay clear of the base of drops and climbs. Secure all items of equipment so that they will not drop on cavers below you. Remember to always yell "ROCK!" for all falling objects, even if it's your water bottle. Saying "WATER!" will take too much time for the person to think when a second of reaction time is all they have.

Hypothermia: If the temperature drops more than a few degrees, the body can no longer function properly. Dress appropriately for the weather and carry extra clothing or something that can protect you from the cold. The first signs of hypothermia are fatigue, drowsiness, exhaustion, unwillingness to go on, feeling cold, poor coordination and stumbling.

Other Hazards: Not all caving problems involve injuries. A few people do get lost in caves, become stuck or are unable to climb up a ledge or rope to get out of the cave. Exhaustion and a lack of light (or light failure) may cause someone to become lost who might otherwise have found their way out of the cave.

A Closer Look Into Safety

As you plan to go on a cave trip, there are several things you should include in your pre-trip planning. Proper preparation will help you have a safe trip and will give some amount of protection against the many dangers of being under ground.

The mere fact that you are interested in caving implies that you are probably comfortable with some level of risk and are somewhat comfortable with the unknown. These are good things, but a person preparing for a cave trip considers the risks, tries to anticipate the problems and thinks about the unknowns. No one wants to have a problem while we are under ground, but we should never go into the cave without at least taking a few minutes to think about the things that can go wrong on our trip.

NEVER Cave Alone

This is dangerous, fool hardy and is a sure recipe for a disaster. The smallest size group recommend is four people. With this number, if someone is hurt, one person can stay and comfort the injured and the other two can get help.

First-time Cavers

There are several things that should be discussed with people who have never been underground before. Discussing the following points with them will help them be mentally prepared, safer and have a better experience.

  1. Three points of contact should be exhibited when moving over uneven ground. This means having three points on your body supported on immovable objects. Whether it is your left foot, right shoulder and knee; your left elbow, head and right hip; or your right hand, bottom and back.
  2. The group needs to stay together. The only reasons not to have people stay together will involve either someone with an injury or an emergency.
  3. Do not exert yourself beyond the limits of your endurance and never do anything that your are not comfortable with. Remember, discretion is the better part of valor. If anyone should have any questions or anxieties, he or she should make their concerns known. It is a team effort when underground.
  4. Do not leave trash behind, pick up others' trash, do not vandalize and do not take souvenirs. Everyone should know the importance of cave conservation on the trip. The caver's motto: Take nothing but pictures, leave nothing footprints, kill nothing but time.
  5. Have an emergency plan and discuss what will be done if something goes wrong. Everyone should know to wait for instructions from the trip leader, unless he or she is in a life-threatening situation. They need to understand that the trip leader makes the decisions in case of an emergency.

Getting Equipped

Every caving trip requires the same basic equipment and supplies. These items include light, head protection (helmet), food, water, first aid kit and proper clothing.

Responsibility

Caving responsibly involves planning a trip, moving through the cave safely and returning on time. You and your partners are responsible for protecting yourselves and the caves you visit.

Tell Someone Your Plans

Establish a time to be out of the cave and a contact person who knows this information. Notify a reliable person about your caving plans, including the name, the location of the cave you are visiting and your estimated time of return. Agree on what to do if you do not return on time. He or she should understand that they will be the person to call for help if you have not checked in with them after the trip should have ended. If you exit the cave after your estimated exit time contact this person as soon as possible to prevent an unnecessary rescue.

Group Size

A good group size is four to six people. Groups larger than six tend to be slow and difficult to manage, so divide a larger group of cavers into separate groups. Each group should have at least one, preferably two, people who are familiar with the cave and good caving skills and practices.

Alertness and Challenges

When caving it is important to remain clear headed. Drugs, including alcohol, that affect your alertness, judgment or ability to think clearly make you a threat to your group’s safety.

Everyone going on the trip should be physically and mentally ready for the challenges that will be associated with the trip. He or she will also need to have the skills required for the kind of cave. For example, does someone have a limiting medical condition? Is someone claustrophobic and you are going on a tight trip? Will everyone on a vertical trip understand on-rope techniques like a change over? The bottom line is, if you think that you or someone else on the trip is not up to challenges that you will be encountering, it is far better to bring it up before a serious problem arises inside the cave.

Hazards

A novice’s apprehension before a caving trip is healthy and an awareness of possible hazards helps you avoid them. Here are some of the dangers of caving.

  • Getting lost
  • Running out of light
  • Hypothermia
  • Passages flooding
  • Falling rocks
  • Poor footing, falling
  • Falling down pits

In addition to making caves available for recreational use, SCCi is also committed to protecting caves and fragile cave ecosystems. The following clean caving procedures are required when visiting SCCi caves. If you have any questions, please email This email address is being protected from spambots. You need JavaScript enabled to view it. or call 423-771-9671.

Introduction of foreign substances into caves can have unintended consequences to cave life. In addition to concerns regarding White-nose Syndrome (WNS), some caves have microscopic life that is unique to that cave, and can be decimated by material introduced from other caves.

CLEAN CAVING PROCEDURES

  • When caving  in WNS positive counties, clean your gear (Steps 1-2 below)
  • When caving between WNS negative counties, clean your gear (Steps 1-2 below).
  • When caving from a county that is WNS positive to a county that has no identified cases, disinfect your gear (Steps 1-5 below).
  • When caving in likely WNS positive counties disinfect your gear (Steps 1-5) going in and, going out, disinfect your gear (Steps 1-5) if visiting WNS negative counties or clean your gear (Steps 1-2 below) if visiting WNS positive counties.

Refer to the following table for the list of counties and SCCi caves that have been identified White-nose Syndrome positive. Any cave located in a county where White-nose Syndrome has been identified should be treated as positive.

State County Preserve WNS Positive
Alabama DeKalb Steward Springs YES
  Jackson Fern YES
  Jackson Horse Skull YES
  Jackson Kennamer YES
  Jackson Limrock Blowing YES
  Jackson Neversink YES
  Jackson Stephens Gap YES
  Jackson Tumbling Rock YES
  Jackson Valhalla YES
  Madison Glove Pit YES
  Madison Varnedoe YES
  Shelby Anderson YES
  Jackson Balcony LIKELY
  Jackson Moody LIKELY
Florida Jackson Hollow Ridge NO
  Marion Jennings NO
Georgia Dade Howards Waterfall YES
  Dade Fox Mountain YES
  Dade Johnsons Crook YES
  Walker Fricks YES
Kentucky Hart Frenchman Knob YES
  Hart Logsdon YES
  Hart Daleo LIKELY
Tennessee Cocke Rattling LIKELY
  Cumberland Run to the Mill YES
  Fentress Wolf River YES
  Franklin Sinking Cove YES
  Marion Gourdneck YES
  Marion South Pittsburgh YES
  Rutherford Snail Shell LIKELY
  Wayne Holly Creek YES
  Hamilton Hugden LIKELY
  Grundy Mayapple LIKELY
  Marion Sinkhole LIKELY
Virginia Russell Cyclops LIKELY
  Giles Salamander LIKELY
West Virginia Pocahontas Lobelia YES

For a map of all US counties and their White-nose Syndrome status visit https://www.whitenosesyndrome.org/resources/map.

Step 1: Get the Dirt Off 

If not completed before leaving the site, thoroughly remove all dirt and debris from all items prior to cleaning and disinfecting. NOTE: If dirt and debris has been transported away from its origin, additional treatment of this debris may be needed.

Step 2: Clean your Gear 

Wash submersible and non-submersible equipment according to manufacturer’s recommendations. Conventional cleansers like Woolite® detergent or Dawn® dish soap may not kill Pd, but they aid in the removal of sediments and debris that may contain spores and increase the effectiveness of subsequent treatment.

Vacuum and wash the inside of field vehicles, especially floor mats and seats used by people who have been inside the bat roosts and cargo areas holding equipment that has been inside the roost. For vehicles that have been driven into or to the entrance of a bat roost, wash the exterior, including undercarriage, before being driven into or to the entrance of another roost. (The best approach is to avoid driving vehicles into or to the openings of roosts.)

Step 3: Disinfect your Gear Use one of the following methods to disinfect your gear:

        Submersible Equipment

Submersible Equipment (i.e., equipment that can safely withstand submersion in hot water or other specified product for the recommended amount of time without compromising the integrity of the item). The preferred treatment for equipment deemed suitable for submersion is hot water that maintains a temperature of at least 55ºC (131ºF) for a minimum of 5 continuous minutes. All equipment surfaces must remain in direct contact (i.e., avoid all trapped air) with the >55ºC (131ºF) water for the entire 5-minute disinfection period. Many commercial and home washing machines with sanitize (or allergen) cycles may be capable of submerging gear in the recommended hot water application for the required time, but each machine should be tested to ensure it reaches and sustains the needed temperatures throughout the process. Remember, if heat may affect the safety and/or integrity of the otherwise submersible piece of equipment, consider equipment dedication or an alternative application or product listed in Table 1.

Non-Submersible Equipment

Non-submersible Equipment (i.e., equipment that may be damaged by liquid submersion) Treat all non-submersible equipment using the most appropriate application or product in Table 1 that complies with the equipment manufacturer’s recommendations and product label instructions. Remember, if an application or product may affect the safety and/or integrity of the equipment, do not use it.

Step 4: Rinse

Thoroughly rinse equipment in clean water or wipe with a clean cloth dampened with water, if appropriate. This step is particularly important if the items will subsequently contact humans, animals, or sensitive environments. Allow all equipment to dry prior to the next use.

Step 5: Clean Up

Repeat these steps for equipment bins and non-disposable bags, sinks, countertops, and other surfaces exposed to equipment during the decontamination process using the most appropriate applications or products in Table 1.

Table1

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Safety Disclaimer: You’re responsible for using any of these methods safely. Be sure to follow manufacturer’s recommendations, label instructions, Material Safety Data Sheets (MSDSs), and common sense.