Introduction of foreign substances into caves can have unintended consequences to cave life. In addition to concerns regarding White-nose Syndrome (WNS), some caves have microscopic life that is unique to that cave, and can be decimated by material introduced from other caves.
CLEAN CAVING PROCEDURES
Refer to the following table for the list of counties and SCCi caves that have been identified White-nose Syndrome positive. Any cave located in a county where White-nose Syndrome has been identified should be treated as positive.
|Cumberland||Run to the Mill||YES|
For a map of all US counties and their White-nose Syndrome status visit https://www.whitenosesyndrome.org/resources/map.
Step 1: Get the Dirt Off Remove as much mud as possible while still at the cave entrance. Place gear in a garbage bag and seal shut. Take home for cleaning.
Step 2: Clean your Gear Pre-clean submersible gear by hosing it down well. Use a scrub brush and mild soap if necessary to remove all sediment. When water runs clear, machine- or hand-wash with a mild cleanser. For non-submersible gear (such as cameras and other electronic gear), remove all visible mud by wiping with a damp cloth or scrubbing.
Step 3: Disinfect your Gear Use one of the following methods to disinfect your gear:
Hot Water Bath Soak gear in hot water that is at least 122°F (50°C) for at least 15 minutes. Top-loading washing machines may be used if the hot water heater temperature is set high enough. Tubs or baths also work, using either hot tap water, or hot tap water supplemented by heated water.
Chemical Solution Bath Soak your gear for at least 10 minutes in a bath or tub one of the following solutions:
Rinse your gear thoroughly after removing it from the bath, being careful not to let it touch any potentially contaminated surfaces. Soft gear and clothing may be run through a washing machine. The recommended Lysol products are available from janitorial supply stores and online sources; household bleach is widely available at grocery and other retail stores. If you don’t get a lot of silt and clay in your tub, Lysol baths have been demonstrated to be effective for at least a month, even with repeated use (Barton, personal communication, 2011). Bleach solutions can weaken nylon and other materials, and must be discarded within 24 hours, because the diluted bleach breaks down quickly.
Non-Submersion Methods For gear that cannot be submersed in water, use one of the following methods:
Safety Disclaimer: You’re responsible for using any of these methods safely. Be sure to follow manufacturer’s recommendations, label instructions, Material Safety Data Sheets (MSDSs), and common sense.